[Novalug] Re: [Ma-linux] Installed new SATA PCI RAID controller, need guidance

[Mike Shade]

Hi Jay --

Newegg says the card supports linux, and I think I had a similar card that
probably uses the same module.  Trying to remember what that was...

But, if lspci doesn't pick it up, you my want to try reseating the card.
lspci doesn't care about drivers, it just reports what it sees on the bus.

-- Mike

On Feb 17, 2008 10:58 AM, Jay Hart <jhart at kevla.org> wrote:

> Ok, here is what I installed:
>
> SIIG SC-SATR12-S4 SATA PCI RAID controller.  Box doesn't say anything
> about
> Linux or other non-M$soft OS support, but I figured, what the hey, I'll
> give
> it a go.
>
> I'm trying to determine if my system picked it up.
>
> The card is for RAID 0 and 1 configs, but I figure it might also work with
> only a single drive. Not nothing but time to lose at this point.
>
> lspci doesn't appear to see card. I'll have to supply this output in a
> follow-up email.
>
> Any thoughts?
>
> I boguth this card because of all the cards at Microcenter, it looked the
> most
> promising.
>
> Jay
>
> _______________________________________________
> Ma-linux mailing list
> Ma-linux at calypso.tux.org
> http://calypso.tux.org/cgi-bin/mailman/listinfo/ma-linux
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://calypso.tux.org/pipermail/novalug/attachments/20080217/95c1b714/attachment.html